Installing Cutting Machine Felt Belt is very Simple and Fast
First, wear Felt Belting on the machine
Pass Novo Belt through the bottom roller and place the open teeth on both sides of the cutting table to facilitate subsequent joints
Second, the tooth weight is well pressed
After aligning Cutter Mat, use weights on both sides of the open teeth of the Felt Belts to prevent slippage.
Third, glue
Apply glue evenly around the diamond teeth. Pay attention to pad some waste paper when applying glue to prevent glue from leaking to the table and block the air inlet.
Fourth, the tooth bonding
After the glue is applied, align the two sides of the teeth and press them to level.
Five, press teeth to ensure neatness
Make sure that the teeth and teeth are aligned neatly to prevent deviations after the joint.
Six, hot pressing
Place a super long Teflon cloth under the joint, and adjust the industrial iron to 80 degrees for preheating. After the preheating is completed, place a rectangular Teflon cloth on the underside of the iron for ironing back and forth on the teeth.
Seven, chisel
We recommend using hard objects to help us remove the glue left on the teeth and make the teeth press.
Eight, edge banding
Stick the edge cloth to the left and right sides of the joint, and press it with an iron.
The above is the installation method of Cutting Machine Felt Belt. If you need any help, please contact us, thank you.
Comments